Email this page to a friend to share information from SharpUSA.com. Just fill out the fields below and press Send.
(Limited to 500 characters)
Register for My SharpSign In to My Sharp
Have a question? It’s probably been asked before. Access answers to frequently asked questions about product operation, troubleshooting, and more. Just enter the product category below.
Results per page
To ensure maximum cooling capacity and efficiency you should keep the filter clean. During peak usage times the filter should be inspected on a weekly basis to make sure that it is not clogged with dust.
On our models greater than 8,000 BTU/hr. the units are manufactured with a slide out chassis to make installation a breeze. The cabinet is set in place without the chasis in it, and then when it is secured you slide the cooling unit into the cabinet.
The EER, or Energy-Efficiency Rating, measures the air conditioner's energy consumption and efficiency. A high EER rating means less energy is being consumed.
Sharp's Limited Warranty is 5 years on the Sealed Cooling System, 1 year on all related parts and 1 year on related labor and in-home service.
The cooling capacity of an air conditioner is measured in British Thermal Units (BTU), and the capacity you require depends mostly on the size of the room you need to cool. If you buy an air conditioner that is to small for the room it will not cool adequately. If you buy one that is too large, the air conditioner will cool the room before it dehumidifies and this can leave you feeling clammy. For larger areas, sometimes two smaller units are more efficient than 1 large unit. You can use the following chart as a rough guide, your Sharp dealer will have additional details.
Check to see if the AM Loop antenna that comes supplied with the stereo has been attached.
Please reset the "Time display" mode to either "AM12:00" or "AM 0:00". See "To Switch the Time Display Mode" located in the "Setting the Clock" section of your operational manual. If the display mode does not change, please call us at 1-800-BE-SHARP.
This usually indicates that the shipping screws have not been removed from the unit. There are 4 screws. 2 are located in the back of the unit and 2 are on the side. See "Preparation for Use" in your operation manual.
Tablet users can view our full site or experience our mobile optimized site.